<?xml version="1.0" encoding="UTF-8"?><rss xmlns:dc="http://purl.org/dc/elements/1.1/" xmlns:content="http://purl.org/rss/1.0/modules/content/" xmlns:atom="http://www.w3.org/2005/Atom" version="2.0"><channel><title><![CDATA[🔌 Wiring questions need photos + numbers]]></title><description><![CDATA[<p dir="auto">Nobody can debug wiring from "I connected everything correctly but it doesn't work." Show this instead:</p>
<ol>
<li><strong>A clear top-down photo</strong> — every wire visible, good light, no spaghetti hiding the pins.</li>
<li><strong>A sketch of the circuit</strong> — hand-drawn is fine: which pin goes where, where power enters, where ground returns.</li>
<li><strong>Part numbers and supply specs</strong> — exact sensor module, what powers it (USB? 5V adapter? battery?), and what the rail measures <em>under load</em>.</li>
<li><strong>The symptom with numbers</strong> — "reads 0", "reads 4095 constantly", "resets when the motor starts", plus what you already tried.</li>
</ol>
<h3>The gotchas that solve most posts here</h3>
<ul>
<li><strong>No common ground.</strong> Two boards or a board + external supply without shared GND gives garbage or nothing. Tie grounds together, always.</li>
<li><strong>5V into a 3.3V pin.</strong> A 5V sensor output (looking at you, HC-SR04 echo) into an ESP32 GPIO will damage it. Divide down or level-shift first.</li>
<li><strong>Missing pull-ups.</strong> I2C needs them (4.7k to 3.3V is the standard starting point); floating inputs read noise.</li>
<li><strong>Motors and relays on the logic supply.</strong> They droop and spike the rail — the MCU browns out and resets exactly when the motor starts. Separate supply (shared GND), bulk capacitance at the driver, and a flyback diode across relay coils and brushed motors.</li>
<li><strong>GPIO pins can't drive loads.</strong> A pin signals; it doesn't power. Relays, motors, and long LED strips switch through a transistor or MOSFET with its own supply — never straight off the pin.</li>
<li><strong>Decouple like you mean it.</strong> A capacitor close to every IC's supply pins eats the high-frequency noise that causes "random" glitches.</li>
</ul>
<p dir="auto"><em>Post the photo, the sketch, and the measured numbers. Tag with hardware, wiring or sensors.</em></p>
]]></description><link>https://forum.grapesiot.com/topic/82/wiring-questions-need-photos-numbers</link><generator>RSS for Node</generator><lastBuildDate>Thu, 19 Nov 2026 13:02:47 GMT</lastBuildDate><atom:link href="https://forum.grapesiot.com/topic/82.rss" rel="self" type="application/rss+xml"/><pubDate>Sat, 03 Oct 2026 11:40:23 GMT</pubDate><ttl>60</ttl></channel></rss>